10.7
Section 10
Reassembly
10
Figure 10-26. Installing Screen, Spring, and Disc.
1
2
3
4
Install Flywheel Brake Assembly
1. Install the two spacers onto the two brake
assembly screws.
2. Torque them to 9.5 N·m (84 in. lb.). See Figure
10-25.
Figure 10-25. Installing Flywheel Brake Assembly.
Install Breather Assembly
1. Install the breather screen, spring, and disc. See
Figure 10-26.
Figure 10-24. Valve Cover Torque Sequence.
Install New Spark Plug
1. Set the gap on a new Champion
®
RC12YC (or
equivalent) to 0.762 mm (0.030 in.).
2. Install the spark plug and torque it to
24.5 N·m (217 in. lb.).
2. Install the breather cover and torque it to
10 N·m (88 in. lb.). See Figure 10-27.
8. Tighten the rocker pivot with a wrench until a
slight drag is felt on the feeler gauge. See Figure
10-23. Hold the nut in that position and torque
the jam nut to 9.5 N·m (84 in. lb.). Perform the
same adjustment procedure on the opposite
valve.
9. Position a new valve cover gasket on the cylinder
head.
ȱŗŖǯȱ ȱȱȱȱȱęȱȱȱȱ
screws.
11. Using the sequence shown in Figure 10-24, torque
the cover screws to 8 N·m (71 in. lb.).
To Next Page
Loading...
