Kohler Courage XT-6 - Page 76

10.10
Section 10
Reassembly
Figure 10-35. Attaching Flywheel Brake Spring.
Figure 10-38. Installing Speed Bracket.
Figure 10-34. Installing Fuel Tank Studs.
4. Install spacers on both studs. See Figure 10-34.
5. Secure the fuel tank bracket to the crankcase by
ȱȱ¡ȱĚȱȱȱ8 N·m (71 in. lb.).
See Figure 10-33.
Install Flywheel Brake Spring
ȱ ŗǯȱ ȱȱǰȱĴȱȱĚ¢ȱȱȱ
onto the bracket hook. See Figure 10-35.
3. Secure the top of the fuel tank to the crankcase
by installing the two threaded studs. Torque the
studs to 10 N·m (88.5 in. lb.). See Figure 10-34.
Install Governor Assembly
ȱ ŗǯȱ ȱȱȱȱȱȱȱĞȱ
with the lever section up. See Figure 10-36.
Figure 10-36. Installing Governor Lever.
Figure 10-37. Attaching Governor Linkage.
ȱ Řǯȱ ĴȱȱĴȱȱȱȱȱȱ
the top of the governor lever. See Figure 10-37.
Install Speed-Control Bracket
ȱ ŗǯȱ ¢ȱĴȱȱȬȱȱȱȱ
crankcase using the two shorter hex screws. The
ȱ¡ȱȱȱȱȱȱȱĴȱ
of the air cleaner body. See Figure 10-38.
Spacer
Stud
Throttle Linkage
Linkage Spring
Hook
Spring
Shaft