Kohler Courage XT-6 - Page 78

10.12
Section 10
Reassembly
Figure 10-42. Installing Governor Spring.
Install Governor Spring
1. Install the governor spring between the governor
lever and the speed control bracket. See Figure
10-42 and 10-39.
Figure 10-44. Installing Throttle Linkage.
Figure 10-43. Installing Carburetor Gaskets
Install Carburetor Gaskets
1. Place the spacer gasket, cylinder head spacer and
ȱȱĚȱȱȱȱȱȱ
in the order shown in Figure 10-43.
Install Carburetor Linkage
DZȱ ȱȱȱěȱ¢ȱȱĴȱ
the carburetor linkage depending on the
carburetor and speed bracket used. For more
detailed illustrations, refer to Figures 10-39,
10-40, and 10-41.
2. Slide the carburetor onto the mounting studs. See
Figure 10-45. Install the air cleaner gasket onto
the studs.
Install Carburetor with Choke
1. With the carburetor not yet mounted on the
studs, rotate it slightly and slot the elbow, at
the end of the linkage, into the choke lever. See
Figure 10-46.
Figure 10-45. Installing Carburetor (Primer Model).
Install Carburetor with Primer
1. With the carburetor not yet mounted on the
studs, rotate it slightly to allow connection of the
ĴȱȱȱȱȱȱȱĴȱ
lever. See Figure 10-44.
Heat Shield
Head Spacer
Spacer Gasket
Throttle Lever
Throttle
Linkage
Spring
Linkage