Kohler Courage XT-6 - Page 79

10.13
Section 10
Reassembly
10
ȱ Řǯȱ ȱȱĴȱȱȱȱȱ
ȱȱĴȱȱȱȱǯȱȱȱ
10-44.
3. Slide the carburetor onto the mounting studs. See
Figure 10-45.
Figure 10-46. Attaching Choke Linkage.
Adjust Governor
1. Move the governor lever away from the
carburetor to the limit of its travel (wide-open
ĴǼǰȱȱȱȱȱǯȱȱȱǰȱ
Ě¡ȱȱȱȱǯȱȱȱȱĞȱ
ȱȱȱȱȱȱĞȱȱȱȱ
as it will go, while simultaneously tightening the
hex nut. See Figure 10-47. Torque the hex nut to
9.5 N·m (84 in. lb.).
Figure 10-47. Adjusting Governor.
Connect Fuel Line
1. Slide the fuel line tight up against the carburetor,
and secure the connection with a hose clamp. See
Figure 10-48.
Install Air Cleaner Assembly
ȱ ŗǯȱ Ĵȱȱȱȱȱȱȱǻȱ
equipped). See Figure 10-49.
2. Slide the air cleaner gasket onto the carburetor
studs. See Figure 10-49.
Figure 10-48. Connecting Fuel Hose.
Figure 10-49. Installing Primer Hose (If Equipped).
Air Cleaner
Base Gasket
Primer
Hose