Kohler Curtis AC F2-C User Manual

4 — PROGRAMMABLE PARAMETERS
pg. 47
Return to TOC Curtis AC F2-A, F4-A, F6-A Motor Controllers – FOS 4.5 – April 2022
INDUCTION MOTOR (ACIM) PMAC (PERMANENT MAGNET MOTOR)
MOTOR SETUP ................................................................ p. 131
~ Max Speed Controller Limit
— Typical Max Speed
— Motor Technology
— Position Sensor Type
— Swap Motor Direction
— INDUCTION MOTOR (ACIM) .................................. p. 132
— Motor Type
— FIELD WEAKENING ...................................... p. 132
~ Base Speed Captured
— FW Base Speed
~ Test Field Current
— Field Weakening Drive
— Weakening Rate Drive
— Min Field Current
— LIMITED OPERATING STRATEGY (LOS) ......... p. 134
— LOS Upon Encoder Fault
— LOS Max Speed
— LOS Max Current
— LOS Max Mod Depth
— LOS Accel Rate
— LOS Decel Rate
— CHARACTERIZATION TESTS ......................... p. 135
— Test Enable
— Test Throttle
— Motor Poles
— Max Test Speed
— Max Test Current
— SlipGain
— Current Reg Tuning Test Enable
— CURRENT REGULATOR ................................ p. 136
— Tuning Voltage
— Kp d Axis Current
— Ki d Axis Current
— Kp q Axis Current
— Ki q Axis Current
— MOTOR SETUP STATUS ............................... p. 136
~ Current Regulator Setup
~ Slip Gain Setup
~ Base Speed Setup
~ Automated Test Run
MOTOR SETUP ................................................................. p. 131
~ Max Speed Controller Limit
— Typical Max Speed
— Motor Technology
— Position Sensor Type
— Swap Motor Direction
— PMAC (PERMANENT MAGNET MOTOR) ................ p. 139
— Motor Type
— Override Short Circuit Current Protection
— COMMISSIONING TESTS .............................. p. 139
— Typical Max Speed
— Max Test Speed
— Max Speed Limit
— Max Speed Time Limit
— Motor Type
— Position Sensor Type
— Enable Multiturn Sensor
— Test Enable
— Test Throttle
— Max Test Current
— CR Tune Max Current
— Current Reg Autotune Bypass
— MOTOR DATA VALUES .................................. p. 140
— Kemf (LL) Vrms/kRPM
— COMMISSIONING PARAMETERS ................... p. 141
— Tuning Voltage
— Phasing order
— Position Sensor Offset
— Position Sensor Compensation
— Kp 1 Current
— Ki 1 Current
— Kp 2 Current
— Ki 2 Current
— Sin Min
— Sin Max
— Cos Min
— Cos Max
— Rsys
— Switch Hall Position X (X = 0-5)
— Switch Hall Pattern X (X = 0-5)

Kohler Curtis AC F2-C Specifications

General

Brand	Kohler
Model	Curtis AC F2-C
Category	Controller
Language	English