Kohler K-498 - Troubleshooting: Reduced Sprayhead Flow; Cleaning or Replacing Sprayhead Screen

Correcting Reduced Water Flow – Sprayheads
If your sprayheads begin to show reduced flow or performance, follow these steps. If performance does not
improve, contact your local service representative.
Clean/Replace the Screen
Turn off the water.
Loosen the setscrew with a hex wrench.
Carefully remove the sidespray from the supply tube.
Remove the screen from inside the supply tube.
Clean or replace the screen as needed.
Insert the screen into the supply tube as shown.
Slide the sidespray over the supply tube.
Tighten the setscrew to secure the sidespray to the supply tube.
Setscrew
Sidespray
Screen
Supply
Tube
Kohler Co. 11 1000706-5-D