D.
Install upper cylinder baffle
(K482.
K532)
then install cylinder head shrouds to complete
installation of cooling baffles and shrouds.
Note:
On
earlier
K482
models make sure new
oil filter is in place before
#2
shroud is installed.
STEP
17
-
Instrument, Control Panel: On engines so equipped, attach panel to bearing housing. On
-
K662
models, remove acorn nut on breather, attach upper bracket supports to stud then
replace acorn nut. Refer to wiring diagrams (see Section
6
and
7)
for proper connections of
electrical equipment. Connect throttle, choke, ammeter and oil pressure gauges.
RUN
-
IN INSTRUCTIONS
Refer to appropriate Service Section for adjustment procedures for carburetor, governor,
etc.
After initial adjustment, fill engine to proper oil level mark with non
-
detergent type oil and run in
under load for a period of about
5
hours.
Make final adjustments as needed during this period. After
the initial
5
hour run in, stop engine,
drain the ail and refill with detergent type API Service SC oil of
proper weight.
To Next Page
Loading...
Need help?
General
