87
L X
N
P
L
Fig. 7.37
Fig. 7.36
Fig. 7.39
B
C
A
DE
Fig. 7.38
ED0053030410
INFORMATION FOR DISASSEMBLY
Warning
• The connecting rod half-bearings Z are made of special
material. Therefore, they must be replaced every time they
are removed to prevent seizures.
2 - Pull out the connecting rod - piston assembly from position
2 and 3 by manually applying pressure on the connecting
rod M in the direction of arrow AK.
3 - Couple the connecting rod big end caps L with the relevant
piston and connecting rod unit M.
4 - Rotate the crankshaft by 180°.
5 - Repeat points 2 to 5 to disassemble the connecting rod -
piston assembly to position 1 and 4.
7.12.2 Timing system gear disassembly
1 - Unscrew screws A and remove the gear B.
2 -
Remove the gear C.
3 -
Unscrew screws D and remove the gear E.
To Next Page
Loading...
