Kohler l654 - Page 24

Figure 6-7. Removing Plug from Voltage
Sensing Relay (VSR) (4.5kW-7kW)
5. Remove the top housing (Figure 6-8) (3.5 and 4.5kW
single).
6. Remove the exhaust tube (Figure 6-9) (3.5kW-7kW).
7. Remove the side housings (3.5kW-7kW).
8. Remove the inside housings (Figure 6-10) (3.5 and 4.5
kW single).
9. Loosen the vibro-mounts (Figure 6-11) and lift the gen-
erator from the base.
10. Tilt the generator end up and place blocks under the
generator adapter.
Figure 6-9. Exhaust Tube
Figure 6-10. Inside Housing Removal
Figure 6-8. Top Housing Removal
Figure 6-l I. Vibro-Mounts
6-3