TP-6881 7/15 115Section 6 Disassembly/Reassembly
Repositioning the engine and alternator
8. Position a 273 mm (10-3/4 in.) block of wood to
support the back corner of the mounting plate.
Note: If the corner of the mounting plate is not
supported, the weight of the engine and
alternator assembly can bend the sheet metal.
9. Connect a hoist to the lifting holes in the mounting
plate. Lower the alternator and engine assembly
and align the screw holes in the mount plate with
the holes in the a lternator box.
Note: Use a hoist or lifting device that is rated for
the weight of the generator set. See
Section 6.1.
10. Connect the mounting plate to the alternator box
with six hex head screws.
11. Reposition the bulkhead and secure with five hex
head screws.
1. Support block
TP-6881
1
Figure 6-17 Support Block
1. Mounting plate lifting hole
2. Mounting plate screws
TP-6881
1
2
Figure 6-18 Mounting Plate
To Next Page
Loading...
