6
1128227-A01-D Date: 13/8/2010
PRODUCT REQUIREMENTS
A. Summary Of Key Requirements
• Observe all local plumbing codes.
•
• Provide properly-dimensioned framing.
• Baths with airjets are designed for a variety of
installations, depending upon the model chosen.
between the valves and spout may be required.
that may inadvertently be used as a means of support
are not appropriate or safe for this installation.
D. Product Inspection
Carefully unpack and inspect the bath with airjets
for damage. Leave all materials in the carton during
construction to prevent damage.
C. Electrical Requirements
The installation must have a Class A Ground-Fault
Circuit-Interrupter (GFCI). The GFCI protects against
Line-to-ground shock hazard. Use a 220-240 V, 10A
(minimum), 50 Hz dedicated service for the bath with
airjets.
PRODUCT NOTICES
WARNING: Risk of electrical shock. A licensed
electrician should make all electrical connections.
WARNING: Risk of electrical shock. Connect
only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage
Circuit-Breaker (ELCB).
WARNING: Risk of electrical shock. Disconnect
WARNING: Risk of injury or property damage.
Please read all instructions thoroughly before
beginning installation, including the following
Product Requirements.
WARNING: Keep the area around the blower
motor clean and free of debris.Ensure that the
area around the blower motor is free of sawdust,
insulation, dirt, or other small loose debris. Such
material could clog the blower motor air ducts and
cause unsafe operation or affect performance
of the bath with airjets. Do not relocate the
system in the absence of kit instructions, as this
could adversely affect the performance and safe
operation of the bath with airjets. Kohler NZ shall
not be liable under its warranty or otherwise for
personal injury or damage caused by any such
A. Installation Hazard Notification
B. Plumbing Specifications
INSTALLATION REQUIREMENTS
A. Tools Required
• Adjustable pipe wrench
• Rule
• Level
• Safety shoes
• Safety glasses
• Square
• Screwdriver
• Pliers
• Utility knife
• Pencil
• Measuring Tape
B. Materials Required
• Plumber’s putty
• Wall coverings, as
necessary
• Silicone sealant
• Gypsum cement
(optional)
• Construction adhesive
(optional)
•
Protective covering for
bathtub
• Nails
• Silicone Sealant
Plus:
• Conventional woodworking tools and materials or
conventional bricklaying tools and materials
• Drop Cloth
• Construction adhesive (optional)
• Cement or mortar (optional)
• 2x4s or 2x6s
• PVC Cement
To Next Page
Loading...
