Kohler Various User Manual

2
• Test meter leads before use. (Set meter to Ohms and check for resistance reading of less than 0.5 Ohm.)
• If available, use clamping meter leads to assist with testing.
• Set meter to next highest voltage scale that includes 12 VDC.
• When taking readings, allow the meter to stabilize before recording. The reading should stabilize after 3 to 5
seconds. If reading continues to drop while cranking, stop the test and perform a battery load test.
Solenoid Shift Starter Warranty Test Procedures
+ -
+ -
+ -
+ -
+ -
-
+
Test #1
Battery Voltage Test (Static)
DVOM
Battery
NOTE: Touch meter
leads to actual battery
terminals.
VDC
Test #2
Voltage Drop Across Battery (Cranking)
DVOM
Battery
VDC
Test #3
Voltage Drop Across Starter (Cranking)
NOTE: Use starter
end plate as test
point.
DVOM
Starter
VDC
Test 1 Conclusions
• If baery voltage is above 12.4
VDC continue to Test 2.
• If voltage is below 12.4 VDC,
charge baery and retest.
• If baery will not hold a charge
it should be replaced before
continuing the test or replacing
the starter.
Test 2 Conclusions
• If baery cranking voltage is
above 9.0 VDC continue to
Test 3.
• If baery cranking voltage is
below 9.0 VDC you should
check the baery by using
a load tester. Also check for
external engine load.
Test 3 Conclusions
• If the dierence between test
2 and test 3 is greater than 1
VDC check all positive and
negative electrical connections
for corrosion and/or loose
fasteners in the starter circuit.
• If additional starter testing
is necessary, refer to proper
service manual for complete
troubleshooting information.

Kohler Various Specifications

General

Brand	Kohler
Model	Various
Category	Engine
Language	English