AIR HANDLING UNIT FUTURE
INSTRUCTIONS FOR OPERATION AND MAINTENANCE
Humidifying secon, evaporaon FKTK
2017-02-13 V. 2.0 31
10.3. Maintenance
• Make sure that the drop separator units are clean and intact.
• Clean, if necessary. Clean the coil gently with a brush, compressed air or a vacuum cleaner. If the unit
has water drains, the coil can be cleaned with water and a mild detergent. NOTE! Do not use pressure
cleaning.
• Check and clean the condensation water discharge system, i.e., drip tray, piping and water trap.
• Damaged drop separator units must be repaired in place, sent to the manufacturer to be repaired or
replaced.
CAUTION
Also observe the manufacturer’s instructions for maintenance.
To Next Page
Loading...