Kollmorgen Seidel SERVOSTAR 601 - III.7.1; Connection to Stepper-Motor Controller with 5 V Signal Level (X5); III.7.2; Connection to Stepper-Motor Controller with 24 V Signal Level (X3)

III.7.1 Connection to stepper-motor controller with 5V signal level (X5)
This interface can be used to connect the servo amplifier to a stepper-motor controller with 5V sig
-
nal level. The connector X5 must be used.
Edge frequency: 1,5MHz
AGND and DGND (connector X3) must be joined together !
III.7.2 Connection to stepper-motor controller with 24V signal level (X3)
This interface can be used to connect the servo amplifier to a stepper-motor controller with 24V sig
-
nal level. The digital inputs DIGITAL-IN 1 and 2 at connector X3 must be used.
Edge frequency: 100 kHz
AGND and DGND (connector X3) must be joined together !
- A.4.031.1/10,45
SERVOSTAR
®
601...620 Installation Manual 49
Seidel 06/02 Interfaces
SERVOSTAR 600
SERVOSTAR 600