Kolver EDU 2AE Series - Page 6

Vers. 120723 6
9) Final Spd (Final Speed): You can select any speed value of the screwdriver between the maximum and
the minimum specific speed of every single screwdriver (see table with technical data).
10) Run time: You can set the time of a tightening, from OFF to 20.0 sec. When the pre-set time has been
reached, it results in a torque signal.
The couple reached during this time results in a signal of Correct screw. If the correct screw signal is not
required, set the Minimum time up to a value of 'Minimum Time -0.1sec'.
ATTENTION: Max Time must be set at 20.0 sec.
11) Min Time - Minimum Time: You can set this time from 0.1 sec to 'Max time - 0.1s'. To disable the
function select OFF by pressing as many times as needed. (Min time = 0).
Torque reached below the minimum time won’t activate the torque signal and will result in an error signal.
“Below minimum time” will be displayed on the status bar and the red led will light up. You will hear two
beep sounds, too.
12) Max time - Maximum time: You can select the maximum time of tightening. You can set from 'Min
time + 0.1s' to 20.0 sec.
You also can set the Maximum time to OFF by pressing the button when you have reached the value of
20.0s. In this case the screwdriver turns without any time limit.
ATTENTION: If torque isn’t reached by the maximum time, the screwdriver will stop. “Over maximum time”
will be displayed on the status bar and the red led will light up. You will hear two beep sounds, too.
13) Pre-Rev. (Pre-reverse): You can set a reverse before a screwing.
Time can set from OFF to 20.0 sec.
ATTENTION: Pre-reverse speed and torque are the same as Auto Rev.
14) Auto Rev: This option will automatically start a reverse after a torque reached/ correct screw signal. You
can set time from 0.1 to 20.0 sec.
To disable the function select OFF by pressing as many times as needed.
ATTENTION: During the reverse, it is necessary to keep the lever or the start signal pressed as long as it
won’t stop. “Correct screw” will be displayed on the status bar and a green led will light up. You will hear
one beep sound, too. In case the lever is released before the end of the reverse, “unfinished screw” will be
displayed and a red led will light up. You will hear two beep sounds, too.
15) Rev speed – Reverse speed: You can select any reverse speed value of the screwdriver between the
maximum and the minimum specific speed of every single screwdriver (see table with technical data).
-
-
-
-
-
-
-
-
M
E
N
U
-
-
-
-
-
-
-
-
1
2
)
M
a
x
t
i
m
e
:
2
0
.
0
s

1
3
)
P
r
e
R
e
v
:
o
f
f

1
4
)
A
u
t
o
R
e
v
:
2
0
.
0
s
-
-
-
-
-
M
E
N
U
-
-
P
R
:
1
-
-
-
-
-
1
5
)
R
e
v
s
p
d
:
6
0
0
r
p
m

1
6
)
R
e
v
t
o
r
q
u
e
:
M
A
X
1
7
)
P
V
t
o
r
q
u
e
:
o
f
f