.
SAFETY
GENERAL PRECAUTIONS
HANDRAILS AND STEPS
To prevent personal injury caused by slipping or falling off the machine, always do as follows.
Use the handrails and steps marked by arrows in the diagram on
the right when getting on or off the machine.
To ensure safety, always face the machine and maintain
three-point contact (both feet and one hand, or both hands and
one foot) with the handrails and steps to ensure that you support
yourself.
When entering the cab, stand on the top step before opening the
door.
Do not grip the control levers and safety lock lever when getting
on or off the machine.
Never climb on the engine hood or covers where there are no
non-slip pads.
Never move from the step at the rear of the machine or the step
at the side of the cab to stand on top of the tire.
Before getting on or off the machine, check the handrails and steps, and if there is any oil, grease, or mud on
them, wipe it off immediately. In addition, repair any damage and tighten any loose bolts.
Do not get on or off the machine while holding tools in your hand.
MOUNTING AND DISMOUNTING
Never jump on or off the machine. Never get on or off a moving machine.
If the machine starts to move when there is no operator on the machine, do not jump on to the machine and try
to stop it.
NO PEOPLE ON ATTACHMENTS
Never let anyone ride on the work equipment, or other attachments. There is a hazard of falling and suffering serious
injury.
2 - 15
To Next Page
Loading...
Need help?
General
