How to switch off service mode in Komfovent Temperature Controller?
The service mode on your Komfovent Temperature Controller is a temporary mode typically activated by service personnel. To switch it off, simply delete the alert message.
Why is the extract air flow low in my Komfovent Temperature Controller?
If you notice a low extract air flow in your Komfovent Temperature Controller, it's likely due to high resistance within the ventilation system. Inspect the pressure pipes, air dampers, and air filters, and confirm that the ventilation system is free from blockages.
Why is the electric heater off in my Komfovent Temperature Controller?
If the electric heater of your Komfovent Temperature Controller is off, it may be due to it being disconnected because of too low air volume. Once the heater cools down, the protection will reset automatically. Increasing the ventilation intensity level is recommended.
What to do if the electric heater overheats in Komfovent Temperature Controller?
If the electric heater in your Komfovent Temperature Controller overheats, it means the emergency overheating protection has been activated. You can reset this protection by pressing the RESET button located on the heater.
Why is the heat exchanger icing in my Komfovent Temperature Controller?
If your Komfovent Temperature Controller's heat exchanger is icing, it might be due to low outdoor temperatures combined with high room humidity. To address this, check the operation of the rotation heat exchanger drive or the air bypass damper of the plate heat exchanger.
What does 'Service time' mean on Komfovent Temperature Controller?
If your Komfovent Temperature Controller displays a periodic inspection message, it means the unit has been in continuous operation for 12 months without breaks. Disconnect the unit from the power supply and carry out a periodic inspection, checking the condition of the heat exchanger, heater, and fans.
What to do if water temperature sensor fails in Komfovent Temperature Controller?
If the water temperature sensor fails in your Komfovent Temperature Controller, it indicates that the water temperature sensor is either not connected or broken. Check the connections of the sensor, and replace it if needed.
What to do if evaporator air temperature sensor fails in Komfovent Temperature Controller?
If the evaporator air temperature sensor fails in your Komfovent Temperature Controller, it means the evaporator air temperature sensor is either not connected or broken. Check the connections of the sensor and replace the sensor if necessary.
Why is the supply air temperature low in my Komfovent Temperature Controller?
If you're experiencing a low supply air temperature with your Komfovent Temperature Controller, it indicates that the heating equipment isn't operating correctly or its capacity is insufficient. You should check the heating equipment.
Why is the evaporator icing in my Komfovent Temperature Controller?
If the evaporator in your Komfovent Temperature Controller is icing, it's likely due to excessively high humidity in the exhaust air combined with low outdoor temperatures. Check the operation of the evaporator defrost system.
Connects air handling unit sections via specified cables and wires.
Details connecting the air handling unit to the electrical power supply safely.
Connects external control elements to the controller box terminals.
Instructions for installing supply air and water temperature sensors correctly.
Specifies environmental conditions for installing the control console.
Explains how to connect the control panel to the unit's controller box.
Describes the air handling unit's control system and components.
Explains the symbols and displays on the control panel.
Presents an overview of key unit parameters on the control panel.
Details the six available operation modes for the air handling unit.
Guides on navigating the control panel menu structure.
Details on accessing parameters, malfunctions, and efficiency status.
Allows activation and setting of additional unit functions.
Plans unit operation based on weekly and annual calendars.
For air handling unit and user parameter settings.
Instructions for controlling the unit via a web browser.
Explores advanced control functionalities for the unit.
Controls mixing valve actuator for heating and cooling modes.
Stepless control of compressor for DX coolers.
Manages cooling steps for direct evaporation coolers.
Option to switch coolers to heating mode.
Provides guidance on diagnosing and resolving unit failures.
General| Brand | Komfovent |
|---|---|
| Model | C5.1 |
| Category | Network Router |
| Language | English |
To Next Page
