Komfovent DOMEKT - Kitchen Hood Installation; Control Contacts Connection

4
Installation Manual
1.3. Kitchen Hood Connection
Air handling units KOMFOVENT DOMEKT REGO 200VE have possibility of kitchen hood connection (in the
functionaldiagramitismarkedbyKH).Aftershingthecablethroughtherubbergasket,(locatedinthewall)it
has to be connected to connection box J11.(see 1.3 Picture).
Connector connection is performed strictly according to numeration given in wir-
ing diagram, or adequate markings (see wiring diagram).
When disconnecting unit sections, do not pull by connecting wires and cables!
Before starting any operations inside the unit, make sure that the unit is switched
off and the power supply voltage is shut off.
1.3 Picture
Kitchen Hood Connection
1.4. Control Contacts Connection
Air handling units with the C4 controller have the connection of additional device (switch, sensor, timer, button etc).
For this function external cable is brought out from the unit (see 1.4 Picture). Detailed description of connection pos-
sibilities is provided in chapter 2.6.
1.4 Picture
Connection of additional control device