2
Before making copies
2-28 200/250/350
Before making copies Chapter 2
Automatically conserving energy (Low Power mode)
If no operation is performed for a specified length of time, the touch panel go
off, and the machine enters a mode where it conserves energy.
This is the Low Power mode.
The machine can receive jobs even while it is in Low Power mode.
As the factory default, the machine enters Low Power mode after 15 minutes.
To recover from Low Power mode
1 Press any key in the control panel or touch the touch panel.
– The Low Power mode can also be canceled by opening the original
cover or loading a document into the ADF.
2 The machine can receive jobs while it is warming up.
– The touch panel comes on again and, after the machine has fin-
ished warming up, it is ready to begin printing (within 14 seconds at
normal room temperature (73.4°F)).
!
Detail
The length of time until the machine enters Low Power mode can be set
from Utility mode. For details, refer to “Low Power Mode” on page 11-13.
Automatically conserving energy (Sleep mode)
If no operation is performed for a specified length of time, the machine auto-
matically enters a mode where it conserves energy.
The machine conserves more power in Sleep mode than in Low Power
mode.
As the factory default, the machine enters Sleep mode after 1 minute.
To recover from Sleep mode
1 Press any key in the control panel or touch the touch panel.
– The Sleep mode can also be canceled by opening the original cover
or loading a document into the ADF.
To Next Page
Loading...
Need help?
General
