bizhub C658/C558/C458/C368/C308/C258 3-17
3.2 Scan-to-Send function
3
Basic Settings and Operations Chapter 3
5 Registering destinations
% Register destinations to which files are sent while checking the checklist. For details, refer to
page 3-22.
Operation flow
The following describes a transmission flow. For details, refer to page 3-24.
1 Loading the original
2 Selecting a destination
% Select a registered destination, and check the settings such as the file type and image quality.
3 Press the Start key.
% Press the Start key to scan the original.
Checking the cable connection
Check that a LAN cable is connected to the LAN port of this machine and the green LED is on.
Checking network settings of this machine
Tap [Utility], and select [Device Information]. Check that the IP address is displayed.
- In general, the default settings are available for network connection; however, some network environ-
ments require a change on network settings.
- If no IP address is displayed, you need to set up the network. Tap [Utility], and select [Administrator
Settings] - [Network Settings] - [TCP/IP Settings]. Configure the required settings to suit your environ-
ment. For details, refer to the User's Guide CD.
To Next Page
Loading...
Need help?
General
