3-26 bizhub C658/C558/C458/C368/C308/C258
Scan-to-Send function
3
3.2
Basic Settings and Operations Chapter 3
3.2.3 Sending data to your Mac computer (SMB Send)
Send scanned data to a computer on the network.
Once settings are configured, you can send data easily.
Preparation flow
The following describes a preparation flow for sending scanned data. For details, refer to the relevant page.
This preparation is not required the second time or subsequent times.
1 Checking the cable connection (Administrator)
% Check that this machine is correctly connected to the network cable. For details, refer to page 3-27.
2 Checking network settings of this machine (Administrator)
% Check the network settings of this machine. For details, refer to page 3-27.
3 Checking computer information
% Check the information required for Store Address, and fill out the checklist. For details, refer to
page 3-29.
4 Configuring your computer
% Configure settings to share a computer, or create a dedicated folder to receive files. For details, refer
to page 3-29.
5 Registering destinations
% Register destinations to which files are sent while checking the checklist. For details, refer to
page 3-31.
Operation flow
The following describes a transmission flow. For details, refer to page 3-33.
1 Load the Original
2 Selecting a destination
% Select a registered destination, and check the settings such as the file type and image quality.
3 Press the Start key.
% Press the Start key to scan the original.
To Next Page
Loading...
Need help?
General
