What to do if Konica Minolta All in One Printer shows the number of programmed jobs has reached the max. allowance?
If your Konica Minolta All in One Printer says that the number of programmed jobs has reached the max. allowance, it means that the maximum number of jobs that can be programmed has been reached. You should wait until a job has been completed, or delete a current job.
What to do if Konica Minolta bizhub C451 image could not be saved in the User Box?
If the image could not be saved in the User Box due to insufficient HDD capacity on your Konica Minolta All in One Printer, it indicates that the hard disk is full. To resolve this, delete any unnecessary data and then try saving the data again.
What to do if new IC card or biometric authentication device is not responding in Konica Minolta Software?
Register Authentication Manager again when a new IC card or biometric authentication device has been installed.
How to fix 'Failed to establish an SSL/TLS communication with the device' message on Konica Minolta Software?
To resolve this, you can: (1) Use Web Connection to import a certificate to the device. (2) In the network settings, set "Enable SSL" of OpenAPI to "ON" or "Accept SSL communication only". (3) In the network settings, set "Enable SSL" of TCP socket IF to "ON".
What to do if Konica Minolta All in One Printer shows busy line?
If your Konica Minolta All in One Printer displays a 'Busy line' error when trying to communicate, attempt to communicate with the center again.
What to do if Konica Minolta All in One Printer shows no response?
If your Konica Minolta All in One Printer shows 'No response' when trying to communicate with the center, try communicating with the center again. Also, check the communication environment on the center side.
What to do if my Konica Minolta All in One Printer is unable to specify desired settings?
If you're unable to specify desired settings or print as specified on your Konica Minolta All in One Printer, it may be due to a few reasons. Some functions cannot be combined, so avoid selecting unavailable settings. An incorrect combination of functions may have been specified, so check the settings and specify the functions correctly. Incorrect settings may be specified in the fax driver, so check each setting. Also, the paper size, orientation, and other settings specified in the application may have priority over those in the fax driver, so enter the correct settings in the application. If you are using watermarks, check the watermark settings and ensure the density is not too low. Note that watermarks cannot be printed in graphics applications.
How to fix Konica Minolta All in One Printer cannot connect to the network?
If your Konica Minolta All in One Printer can't connect to the network, it might be due to a connection problem. Ensure the network cable is properly connected. Also, verify that the Network Settings parameters in Administrator mode are correctly specified.
General| Brand | Konica Minolta |
|---|---|
| Model | bizhub C451 |
| Category | All in One Printer |
| Language | English |
To Next Page