SL1000 User’s Guide
5-4
2.3 Errors shown on the Personal Computer Screen
Error message Action
SL-Touch Error
Cannot find the Scanner.
Connect the Scanner to the PC, install the
driver, then boot up the software.
・Start the application after connecting the Scanner
with the Personal Computer, and installing the
driver.
SL-Touch Error
Turn OFF the Power Switch of the Scanner,
and turn it ON again.
Restart the Personal Computer.
• After confirming that the USB Cable is properly
connected, turn ON the Power Switch of the
Scanner again and restart the computer.
SL-Touch Error
CCD Board Error.
Turn OFF the Power Switch of the Scanner,
and turn it ON again.
Restart the Personal Computer.
• After confirming that the USB Cable is properly
connected, turn ON the Power Switch of the
Scanner again and restart the computer.
SL-Touch Error
Zoom Motor Error.
Turn OFF the Power Switch of the Scanner,
and turn it ON again.
Restart the Personal Computer.
• After confirming that the USB Cable is properly
connected, turn ON the Power Switch of the
Scanner again and restart the computer.
SL-Touch Error
Focus Motor Error.
Turn OFF the Power Switch of the Scanner,
and turn it ON again.
Restart the Personal Computer.
• After confirming that the USB Cable is properly
connected, turn ON the Power Switch of the
Scanner again and restart the computer.