What to do if there is no sound or picture on my Konig DVB-T HDMI10?
If you're experiencing a lack of sound or picture, it might be due to a weak or absent signal. Please verify the cable connections, the antenna itself, and any other devices positioned between the antenna and the receiver.
Why is my Konig Receiver showing a bad picture or blocking error?
A bad picture or blocking error on your Konig Receiver can be caused by several factors: * The signal might be too strong, in which case you should connect a signal attenuator to the antenna input. * The antenna noise factor may be too high, so consider changing to an antenna with a lower noise factor. * The antenna itself could be faulty, requiring a replacement.
What to do if there is no sound or picture and the front panel shows red light on Konig DVB-T HDMI10?
If your Konig Receiver shows no sound or picture and the front panel displays a red light, the receiver is likely in standby mode. Try pressing the standby button to turn it on.
How to fix a Konig DVB-T HDMI10 Receiver when the display on the front panel does not light up?
If the display on the front panel of your Konig Receiver isn't lighting up, the main cable might not be properly connected. Ensure that the main cable is securely plugged into the power socket.
To Next Page
General