EN66
ENGLISH
Service
In case of service requests or spare parts,
please contact your local HORNBACH store
or write an email to:
service@hornbach.com
Thank you!
We are convinced that this product will
exceed your expectations and wish you joy
while using it.
Read the instructions before using the ap-
pliance, keep it for further reference and
observe the safety instructions.
Intended use
This product is used as divider and sight protection in private environments.
The appliance is not intended for commercial use.
Any other use or modi cation to the appliance is considered as improper use and could
cause insuries or damage to the product.
Required tools
1x Screwdriver
1x Allen wrench 4 mm
1x Metal drill 3.0 - 3.5 mm
1x Concrete drill 10 mm
1x Hammerdrill
1x Spirit level
Table of content
Intended use 66
Service 66
Required tools 66
Safety Instructions 67
Overview 67
Components 68
Preparation 68
Fix posts directly with screws 69
Set posts in concrete with anchors 70
Assembly 71
Assembly on slopy underground 71
Cutting fence panels 72
Stability 72
Care and maintenance 73
EN 67
1. Post cap
2. Alu end pro le
3. fence panel
4. Alu post
Overview
5. Alu start pro le
6. Decorative element horizontal
7. Decorative element vertical
SAFETY INSTRUCTIONS
∙ Check the product regularly for defects or traces of wear.
∙ This product can not be used as installation for statical support.
∙ The product is not to be used as a falling protection and has no general techni-
cal approval for this purpose.
∙ Do not install the posts on unstable or uneven ground.
∙ Not mounted elements can deform when stored wrongly or in a not appropriate
way. Avoid point loading.
∙ Store the elements in a way that they are protected by rain or direct sunlight.
The latter could cause a too strong heating of the material.
∙ Do not install during frost or great heat. The ideal ambient and ground tem-
perature is between +5 °C to +25 °C.
5
4
3
2
7
6
1
To Next Page
Loading...