konsta WPC - Set Posts in Concrete with Anchors; Assembly; Assembly on Slopy Underground

EN70
To set the fence posts in concrete with the help of the anchors (optionally available)  rst
follow steps 1 to 3, then steps 4a and 5a (see below):
Put the posts on to the post anchors and  x
them with screws.
Set posts in concrete with anchors
4a
Put the posts with the anchors upright into
the holes and align them with the help of a
spirit level. Fill concrete into the holes and
compact it with a timber beam!
Fix the posts in the correct position with
the help of poles and clamps.and let the
concrete harden thoroughly (Observe the
indications on the packaging).
Find the further steps on pages 75 to 82,
beginning with step 6.
5a
(optional)
EN 71
Caution
Do not install the product by frost or high temperature. The outdoor temperature
should range between +5 °C and +25 °C. The fence panels should adapt to the
outside temperature before assembly.
The detailed description of the assembly of the fence can be found on pages 74-82.
Assembly
Assembly on slopy underground
A) The course of the fence panels is level at the top.
For this purpose, please cut the optionally available height compensation for the start pro le
B3 to the adequate length to match the required height, and  t it into the post base A1 (a).
Set the fence posts into concrete when installing the fence on a slopy underground. All
posts need to be level. Following two installation options are possible:
B) The posts and fence panels are installed stepped with o set
a
a