15 Dimmer control
Distributed control In the status of non-programming, press SCAN/LIGHT and the
indicating light ON to enter dimmer function; Press SA/SB/SC to select relative dimmer
channel. Move sliders of it to change dimmer.
USER MANUAL
12/12
DMX 512 CONTROLLER SERIES
New features
1.Auto-save last running program when switch off or power off and
continue play last running program while switch ON or power ON again.
2.Play single chase or multi chases in cycle. The indicate led light of
CYCLE/SUP OFF means chase run in cycle.
3, Multi chases (maximum 8 chases) run at the same time. The indicate
led light of CYCLE/SUP ON means multi selected chases run at the
same time.
4, Set different X/Y channel of single scanner.
5, Under auto + manual mix running modes, release single channel or
all channel. Press [MANUAL] and [RELEASE CHANNELS], select
correspondent channel via SA/SB/SC to release it. LCD display will
show status of current channel from O to F. Press [CLEAR] and
release all channels. Then LCD display show status of all channel
fromOtoF.
Press [RELEASE CHANNELS] again to save and quit.
To Previous Page
Loading...
Need help?
General