Page 45
This is the name of the Document
Remove All
Partitions
You can click “Remove All Partitions” to remove all the
partitions in the attached storage device.
Note: The data originally stored in the partitions will be
erased after they are removed.
Reset
You can click “Reset” to reset selection in partition list.
Turn Off Hard
Disks
If you select “Never” then Hard Disk Power Management
function is disabled. If you select an idle time, then Hard
Disk Power Management function is enabled and the
Koobrick Boxi will turn off hard disk drive to save power
after the hard disk idle timeout. When your hard disk drive
is sleeping, any operation which requires reading or writing
hard disk drive will make the Koobrick Boxi wake up the
hard disk drive in a few seconds and the hard disk drive can
work normally as usual.
Note: If you disabled the RAID previously and now want to enable it again. The old
data can be kept correctly after you re-enable the RAID only when all the following
conditions hold. Otherwise, you can only choose to create a new RAID and erase
old data stored in the two internal SATA hard disk drives:
* The RAID mode before you disabled the RAID and the RAID mode that you want
to enable now should be the same.
* The two current internal SATA hard disk drives are the same as the two internal
SATA hard disk drives used before you disabled the RAID.
* You never change any data of both internal SATA hard disk drives after you
disabled the RAID and before you enable the RAID.
Check & Fix Disk
Check & Fix Disk can check and x the le system error of the hard disk drive.
Before start up, a warning window will pop-up to inform you that this action may
damage your data. Click “OK” to continue.
Note: When the Koobrick Boxi is doing Check & Fix Disk for your hard disk drive,
the hard disk drive is occupied. All the services of the Koobrick Boxi will be stopped.
Note: Check & Fix Disk only supports internal SATA hard disk drives.
Boxi User Manual
Version 1.0
To Next Page
Loading...