Part Number STH063 9/17 39
Step 9 Mix a solution of sanitizer and warm water.
Solution Type Water Mixed With
Sanitizer 3 gal. (12 l) 2 oz (60 ml) sanitizer
Step 10 Use half of the sanitizer/water solution to
sanitize all removed components. Use a spray bottle to
liberally apply the solution to all surfaces of the removed
parts or soak the removed parts in the sanitizer/water
solution. Do not rinse parts after sanitizing.
Step 11 Use half of the sanitizer/water solution to
sanitize all foodzone surfaces of the ice machine and bin.
Use a spray bottle to liberally apply the solution. When
sanitizing, pay particular attention to the following areas:
• Evaporator plastic parts - including top, bottom and
sides
• Bin bottom, sides and top
Do not rinse the sanitized areas.
Step 12 Replace all removed components.
Step 13 Wait 25 minutes.
Step 14 Reapply power and water to the ice machine
and place the toggle switch in the ice position.
Step 15 Water will flow through the water dump valve
and down the drain. Wait until the water trough refills,
then add the proper amount of ice machine sanitizer to
the water trough.
Model Amount of Sanitizer
KT0300 - KT0400 - KT0420 - KT0500
KT0700 - KT1000
3 ounces (90 ml)
KT1700 6 ounces (180 ml)
Wait until the sanitize cycle is complete (approximately 24
minutes) then place the toggle switch in the ice position to
start ice making.
To Next Page
Loading...
