KoolMore BIM75-BS - Operation Procedure and Maintenance; Unpacking Your Ice Maker; Door Reversing (Optional)

9
le
H
Hand
andle
Right
bottom
Hinge
Right fix
piece
Left fix
piece
Left
bottom
hinge
Top
Hinge
Top
Hinge
Fix plate
Top cover
OPERATING PROCEDURE & MAINTENANCE
UNPACKING YOUR ICE MAKER
1. Remove the exterior and interior packaging. Check to ensure that all the accessories, including
instruction manual, ice scoop, white water inlet pipe, 4-ways-to-2-ways water quick connector and
the water draining pipe, etc., are inside. If any parts are missing, please contact our customer service.
2. Remove the tapes for fixing the door and inner cabinet, ice scoop, etc. Roughly clean the inner
cabinet & ice scoop with wet cloth.
3. Put the ice maker on a level & flat floor, without direct sunlight or other sources of heat (i.e.: stove,
furnace, radiator). Make sure that there is at least 50cm gap between the air outlet and the obstacles,
and at least 5 cm between the wall.
4. Allow 4 hours for the refrigerant fluid to settle before plugging in the ice maker.
5. The appliance must be positioned so that the plug is accessible.
WARNING: Connect to potable (drinkable) water supply only.
DOOR REVERSING (Optional)
If you want the refrigerator door to open from the opposite side, you can reverse the door swing.
1. Ensure the unit unplugged before starting door reversal.
2. Remove the 2 screw hole cover on the top cover, then unscrew the 2 screw which is fixed in the top
cover.
3. Remove the 2 screws from the top hinge and 2 screws from the fix plate.