ELECTRICAL REQUIREMENT & CONNECTIONS
WARNING: THIS UNIT MUST BE EARTHED
Electrical Shock Hazard
• Plug into a grounding wall outlet.
• Never remove the ground prong.
• Use separate power supply or receptacle.
• Never use an adapter.
• Never use an extension cord.
• Failure to follow these instructions can result in death, fire, or electrical shock.
Before you move your ice maker into its final location, it is important to make sure you have the proper
electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be provided. Use receptacles
that cannot be turned off by a switch or pull chain. If the supply cord or plug needs to be replaced, it
should be done by a qualified service engineer. This appliance requires a standard 110-120Volt, 60Hz
electrical outlet with good grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is equipped with
a power supply cord having a grounding plug. To minimize possible shock hazard, the cord must be
plugged into a mating grounding-type wall receptacle, grounded in accordance with the National
Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the
personal responsibility of the customer to have a properly grounding wall receptacle installed by
aqualified electrician.
CLEANING YOUR ICE MAKER BEFORE FIRST USE
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Open the door to the ice chamber.
2. Clean with diluted detergent, warm water, and a soft cloth.
3. Repeatedly clean the water-contacting inner parts, you can pull the water tank’s drainpipe (labeled
“H” in illustration on Page 5) to drain the cleaned water in the water tank. Then, clean inner ice- storing
cabinet and drain out all of the soiled water from the water drain port located at unit back (labeled “7”
in the illustration on Page 5). Then, reinstall the water drainpipe back into the water tank and put the
cap on the unit water drain port. If not reassembled correctly, the unit will not make the ice normally.
We suggest that you discard the ice-cubes made by the first ice- making cycle after cleaning for
safety purposes.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
To Next Page
Loading...