33
RISK OF ELECTRICAL SHOCK!
• THIS APPLIANCE IS DESIGNED TO OPERATE ONLY
WITH ALTERNATING CURRENT. BEFORE STARTING IT,
MAKE SURE THAT THE VOLTAGE CORRESPONDS TO
THE ONE INDICATED ON THE RATING LABLE.
• CONNECT THE APPLIANCE ONLY TO POWER OUT-
LETS WITH A MINIMUM CAPACITY OF 10 AM PERES.
• DO NOT PULL THE POWER CORD OR THE APPLIAN-
CE ITSELF TO REMOVE THE PLUG FROM THE WALL
SOCKET.
• FULLY UNWIND THE POWER CORD BEFORE OPE-
RATING THE APPLIANCE.
• USE AN ELECTRIC EXTENSION CORD ONLY IF IT IS
IN PERFECT CONDITIONS.
• NEVER LET THE POWER CORD RUN ON SHARP ED-
GES; AVOID CRUSHING IT.
• DO NOT LEAVE THE APPLIANCE EXPOSED TO AT-
MOSPHERIC AGENTS (RAIN, FROST, SUN, ETC.).
• NEVER USE THE APPLIANCE:
- WITH WET OR DAMP HANDS.
- IF IT HAS FALLEN AND HAS OBVIOUS CRACKS OR IN
CASE OF ANY MALFUNCTION.
- IF THE PLUG OR POWER CORD ARE DEFECTIVE.
- IN DAMP OR GAS-SATURATED ENVIRONMENTS.
• DO NOT COVER THE APPLIANCE WITH TOWELS,
CLOTHES, ETC.: DO NOT OBSTRUCT THE AIR INLETS
(THIS MAY LEAD TO ITS OVERHEATING AND IT MAY
LEAD TO DANGER OF FIRE/SHORT CIRCUIT).
• PLACE THE APPLIANCE ONLY ON HORIZONTAL
AND STABLE SURFACES, AWAY FROM SHOWERS,
BATHTUBS, SINKS, ETC.
•DO NOT USE THE APPLIANCE NEAR WALLS, FURNI-
TURE, CURTAINS, ETC.)
To Next Page
Loading...