Korg Ax3G - About Effect and the Parameter; PRE Effects

2
About effect and the parameter
It explains each effect of drive/amp models and cabinet models, modulation, pre-effects, delay, and reverb effects and the parameter.
PRE effects
F0: COMP (COMPRESSOR)
This is the ideal choice when you want to play smooth, clean, and consistent phrases, or when you need a bit
more sustain on a lead line. It models a compressor pedal that was popular for its percussive clean sound.
Main SENS Adjusts the sensitivity. Turn the knob toward the right to increase the amount of
compression and sustain.
P1 LEVEL Adjusts the output level.
F1: PICKUP
This models the way in which a pickup affects the sound. It can transform a single-coil pickup into a humbucker,
a humbucker into a single-coil, or create a model in which two phase-reversed pickups are combined. A compres-
sor is built-in.
Main TYPE Selects the pickup conversion model.
H-S: Humbucking sound will be transformed into single-coil sound.
S-H: Single-coil sound will be transformed into humbucking sound.
P1 LEVEL Adjusts the output level.
P2 PHASE Adjusts the distance of the virtual pickup that's mixed-in.
P3 PHASEMIX Adjusts the mix amount of the virtual pickup. Settings of -10–0 mix the sound in
reverse-phase.
P4 SENS Adjusts the sensitivity of the compressor.
F2: AC SIM (ACOUSTIC SIMULATOR)
This uses the acoustic guitar modeling technology of the ToneWorks AX10A, converting the sound of an electric
guitar into the sound of an acoustic guitar.
Main TOP Adjusts the high-frequency tone.
P1 BODY Adjusts the low-frequency tone.
P2 TYPE Selects the body type.
1: An old-style small body, suitable for detailed arpeggios
2: A small-size body with a distinctive mid-range, favored by country and blues
players
3: A large body characterized by a refined sound, suitable for pop.
4: The body of a resonator guitar, suitable for slide playing
P3 MIX Adjusts the mix amount of body resonance.
F3: WAH (VOX WAH)
This is a detailed simulation of two legendary VOX wah pedals; the V847 and the V848. You can use the CLOSE
and OPEN knobs to adjust the tone when the pedal is closed and open, giving you a wide range of tonal varia-
tion.
Main PEDAL Adjusts the openness (position) of the wah pedal.
P1 TYPE Selects either 47 (V847) or 48 (V848) as the wah type.
P2 ORDER Selects the connection order.
PRE/POST connects the wah before/after the Amp Model.
P3 CLOSE Adjusts the tone when the wah pedal is closed (pedal back).
P4 OPEN Adjusts the tone when the wah pedal is open (pedal forward).