22
5. Select an effect
Press the [GUITAR/MIC] key
The guitar/mic effects will appear.
Use the [VALUE] dial to select an
effect program
Play your guitar to hear the sound.
Edit an effect module
Press the [PAN] knob for one of the effect modules
within the selected effect chain, and then turn the
[VALUE] dial to select that effect module. You can
turn the [PAN] knobs to edit the value of the parame-
ters in that module.
Press the [EXIT] key
You will return to Play mode.
6. Record
Adjust the recording level
Use the [TRACK 1] fader to adjust the recording level.
While you watch level meter [1], gradually raise the
fader as far as possible without allowing the level to
reach CLIP. Use the [MASTER] fader and [PHONE]
knob to adjust the monitor volume.
Arm the D4 for recording
Press the [REC] key to put the D4 into record-ready
mode. The [REC] key will blink.
Record!
When you are ready to perform, press the [PLAY] key.
Recording will start, and you may begin playing your
instrument. During recording, the [REC] key and
[PLAY] key will be lit.
Stop recording
When you’re finished performing, press the [STOP]
key. Recording will stop, and the [REC] key and
[PLAY] key will go dark.
To Next Page
Loading...