Korg D4 - Page 80

78
FLANGER
ST FLNGE (STEREO FLANGER)
These effects give the sound modulation and a sense of pitch
movement.
1. TIME...................[1...10]: Adjusts the delay time, controlling the
frequency range at which the effect will
apply. Adjusting this toward 0 will cause
the modulation to occur at a higher pitch.
2. FEEDBACK..[–10...+10]: Adjusts the unique character of sound.
Raising this setting appropriately will
produce a “jet” effect.
3. SPEED........[0.1...10Hz]: Adjusts the speed at which the pitch is
modulated.
4. DEPTH...............[0...10]: Adjusts the depth at which the pitch is
modulated. When set to 10, the TIME
parameter has no effect.
5. MIX ....................[0...10]: Adjusts the amount of effect mixed into
the sound.
MOD DELAY
ST MODDLY (STEREO MOD DELAY)
These effects can also modulate the delay time to produce
chorus or flanger-like effects.
1. TIME...............[0...1.75]: Adjusts the delay time.
2. FEEDBACK..... [0...+10]: Adjusts the feedback (repeated “echoes”).
3. SPEED........[0.1...10Hz]: Adjusts the speed at which the pitch is
modulated.
4. DEPTH...............[0...10]: Adjusts the depth at which the pitch is
modulated.
5. MIX ....................[0...10]: Adjusts the amount of effect mixed into
the sound.
TREMOLO
TREM/PAN (TREMOLO/PAN)
These effects simulate the tremolo that is built into some gui-
tar amps. TREM/PAN can be selected in CHAIN 1.
1. -----(BLANK)..................
2. SPREAD ............[0...10]: Switches between tremolo and pan. *For
TREM/PAN
-----(BLANK) ................: *For TREMOLO
3. SPEED .......[1.0...10Hz]: Adjusts the speed of tremolo.
....................[0.1...10Hz]: Adjusts the speed of tremolo.
*For TREM/PAN
4. DEPTH.............. [0...10]: Adjusts the depth of tremolo.
5. -----(BLANK) ................:
PTCH SFT (PITCH SHIFTER)
ST PITCH (STEREO PITCH SHIFTER)
These are pitch shifter effects with a ±2 octave range of adjust-
ment.
1. -----(BLANK) .................
2. -----(BLANK) .................
3. PITCH..........[–24...+24]: Adjusts the pitch change amount.
4. FINE.............[–50...+50]: Fine adjustment of pitch change amount.
5. MIX.................... [0...10]: Adjusts the amount of effect mixed into
the sound.
For stereo
1. L PITCH ......[–24...+24]: Adjusts the L ch pitch change amount.
2. L FINE .........[–50...+50]: Fine adjustment of the L ch pitch change
amount.
3. R PITCH......[–24...+24]: Adjusts the R ch pitch change amount.
4. R FINE.........[–50...+50]: Fine adjustment of the R ch pitch change
amount.
5. MIX.................... [0...10]: Adjusts the amount of effect mixed into
the sound.
PHASER
ST PHSER (STEREO PHASER)
These modulate the phase to give a “swirling” character to
the sound.
1. MANUAL......... [1...10]: Adjusts the frequency at which the effect
applies.
2. FEEDBACK ......[0...10]: Adjusts the distinctive tonal character.
3. SPEED .......[0.1...10Hz]: Adjusts the modulation speed.
4. DEPTH.............. [0...10]: Adjusts the depth of the effect.
5. -----(BLANK) .................