Karma EasyStart
5
5. Press the [MENU] key, then press [F1] to highlight “LOOP” Ä Press [F8] to open the Loop Page Ä Hold down the
[TIMBRE/TRACK] key, and press [F2] to select Track 2
Ä Press the [VALUEc
cc
c] key to check Track 2’s loop box Ä
CURSOR b and leave the loop start value at measure “001”
Ä CURSOR b and set the loop end value to the last
measure that you played on Track 2.
6. Repeat steps 4 and 5 as desired Ä Complete your new hit song Ä Go on American Idol and win Ä Make millions of
dollars
Ä Move to the Virgin Islands, buy a generator and play with your Karma on the beach.
New! Alternate quick song method featuring One-Touch Recording:
1. Choose any Program or a Combi Ä
ÄÄ
Ä Tweak the KARMA REALTIME CONTROLS as desired Ä
ÄÄ
Ä Tap the
[TIMBRE/TRACK] key at least 3x to enter a desired tempo.
2. Hold down [ENTER] and press [REC/WRITE] Ä
ÄÄ
Ä Press [F8] to answer “OK” to “Setup to Record: Are you Sure?” Ä
ÄÄ
Ä
KARMA jumps to Record mode, with the [REC/WRITE] key already armed.
3. Press [START/STOP] to begin recording Ä
ÄÄ
Ä Press [START/STOP] again to stop recording. What could be easier?!
New! Tone Adjust in Sequencer mode:
1. Press the [MENU] key Ä Press [F5] until “Tadj”(Tone adjust) is highlighted, then press [F8] to “Open”.
2. Hold down the [TIMBRE/TRACK] key and choose a Track for tonal shaping by pressing one of the [F1] – [F8] keys.
3. Turn the DIAL or use the [VALUEc
cc
c ]/[VALUEd
dd
d] keys to choose from the 25 parameters available for adjusting Ä
CURSOR b to access the “value field” of the chosen parameter
Ä Enter the desired value with the
[VALUEc
cc
c/VALUEd
dd
d] keys, the DIAL, or type in the desired value on the numeric keypad and finalize by pressing
[ENTER].
! Each track may have six of these 25 parameters tweaked at the same time, allowing you to quickly edit a Track’s
Program without having to leave Sequencer mode!
Automating the Mix
1. CURSOR to the Track field and select a track from the steps above for mixing.
2. Press the [F6] “Pref.” key and press the [VALUEc
cc
c] key to select “Over Dub” for “REC setup.”
3. Press the [F4] key to view the Mix for tracks 1-8 ÄWhile holding down the [TIMBRE/TRACK] key, press the [F1]-[F8]
key to highlight the desired Track
ÄCURSOR b once to highlight the volume “wedge” for this Track.
4. Press the [REC/WRITE] key, then the [START/STOP] key, and record volume changes on the track by turning the DIAL
ÄPress [START/STOP] when finished.
5. Press [START/STOP] to audition the results; the volume wedge and value will update as the song plays back Ä Note
that Panning messages may be recorded in similar fashion.
To Next Page
Loading...
Need help?
General
