103
EFFECT
Master EQ
The Master EQ (stereo, three-band EQ) is located right
before (MAIN OUTPUT) L/MONO, R. Low and High EQs
are of the shelving type, and Mid EQ is a peaking type
equalizer. You can control the Low Gain and High Gain
parameters using the Dynamic Modulation function.
The Master EQ (stereo, three-band EQ) is applied to the sig-
nal input from the L/R bus. For more information on the
parameters, p.149.
Individual Outputs
The X50/microX is equipped with two individual INDIVID-
UAL OUTPUT.
You can route the oscillator (Program), timbre (Combina-
tion), and track (Multi) output or the post-IFX signals to
these two individual outputs.
Use “BUS Select” (8–1a) in Program, Combination, or Multi
mode to route the oscillators (Program), timbres (Combina-
tion), or tracks (Multi) to INDIVIDUAL OUTPUT.
If you are using the Insert Effects, use “BUS Select” of the 8:
Ed–InsertFX (or InsertFX), and Setup page to route the post-
IFX signals.
1, 2: Monaural signals are routed to INDIVIDUAL OUTPUT.
1/2: Stereo signals are routed to INDIVIDUAL OUTPUT.
Program mode
Combination, Multi mode
Pan
Oscillator 1
Send1
Select from:
L/R
IFX
1
2
1/2
Off
IFX BUS
IFX
MFX2
MFX1
mono
mono
Return1 / 2
Master EQ
(MAIN OUTPUT)
L/MONO, R
BUS Select
= L/R
Oscillator 2
IFX / Indiv.Out
BUS Select
Insert Effect
Post IFX
Pan(CC#8)
BUS Select
Select from:
L/R
1
2
1/2
Off
Send2
stereo
Master Effects
(INDIVIDUAL
OUTPUT) 1/2
L/R BUS
mono x2
mono x 2
BUS Select
= IFX
stereo
stereo
Chain
Effect / Mixer Block Diagram in Program Mode
PROG 8: Insert Effect
Post IFX
Send1 / 2
PROG 9: Master Effect
Pan
Timbre / Track 1
BUS Select
= L/R
Send1
Select from:
(DKIT)
L/R
IFX
1
2
1/2
Off
BUS Select
= L/R
IFX BUS
IFX
MFX2
MFX1
mono
mono
Return1 / 2
Master EQ
(MAIN OUTPUT)
L/MONO, R
Timbre / Track 2
Timbre / Track 3
BUS Select
= Off
Timbre / Track 4
BUS Select
= 1/2
Timbre / Track 8
BUS Select
= 2
Track 16
IFX / Indiv.Out
BUS Select
Insert Effect
Post IFX
Pan(CC#8)
BUS Select
Select from:
L/R
1
2
1/2
Off
Send2
stereo
Master Effects
(INDIVIDUAL
OUTPUT) 1/2
L/R BUS
stereo
mono x 2mono x 2
BUS Select
= 1
BUS Select
= IFX
stereo
stereo
Chain
Effect / Mixer Block Diagram in Combination / Multi Mode
COMBI/MULTI 8: Insert Effect
Post IFX
Send1 / 2
COMBI/MULTI 9: Master Effect
To Next Page
Loading...
