Korg MICROX X50 - 8-3: IFX (Insert Effect); COMBI 9: Ed-Masterfx; 9-1: Setup

52
8–3: IFX (Insert Effect)
Here you can adjust the parameters for the IFX that was
selected in the Setup page (☞p.104–).
■ 8–3a: UTILITY
☞ “Write Combination” (0–1)
COMBI 9: Ed–MasterFX
☞ For details on master effects, refer to p.97 “6. Effect
Guide.”
9–1: Setup
Here you can select the type of each master effect, turn it
on/off, and make chain and master EQ settings.
With the exception of “MFX1 Control Ch,” “MFX2 Control
Ch,” and “MEQ Control Ch,” this is the same as in Program
mode. (☞PROG 9: Ed–MasterFX)
9–1a: MasterFX Setup
MFX1 On/Off, MFX2 On/Off [Off, On]
Master Effect 1, 2 [00...89: name]
Rtn 1, 2 (Return 1, 2) [000...127]
These are the same as in Program mode. Refer to “PROG 9–
1: Setup.” However, the master effects will be controlled on
the “MFX 1, 2 Control Ch” MIDI channel, unlike in Program
mode.
The control changes used are the same as in Program mode.
MFX 1, 2 Control Ch [Ch01...16, G ch]
Selects the MIDI channel that will control dynamic
modulation (Dmod) for the master effects.
G ch: The global MIDI channel “MIDI Channel” (GLOBAL
1–1a) will be used for control. Normally you will set this
parameter to G ch.
9–1b: MasterFX Chain
MFX Chain [Off, On]
Direction (Chain Direction)
[MFX1→MFX2, MFX2→MFX1]
Signal (Chain Signal) [LR Mix, L Only, R Only]
Level (Chain Level) [000...127]
These are the same as in Program mode. (☞PROG 9–1:
Setup)
9–1c: Master EQ Gain [dB]
Low [–18.0...+18.0]
Mid [–18.0...+18.0]
High [–18.0...+18.0]
These are the same as in Program mode. (☞PROG 9–1:
Setup)
9–1a
9–1b
9–1c9–1d