34
FOOTSW: Foot switch pedal settings
Use the Value encoder to specify the function of the foot
switches connected to the PX5D.
Switch pedal
function
PG: The pedals will switch between the programs as-
signed to the PROGRAM MEMORY [A]–[D] buttons.
The pedal connected to the UP connector (red) of the in-
cluded cable for FOOT SW jack will step upward through
the programs in the order of [A]→[B]→[C]→[D]→[A]→...
The pedal connected to the DOWN connector (white) will
step downward through the programs in the order of
[D]→[C]→[B]→[A]→[D]→...
Ud: The pedals will switch between programs U00–P99.
The pedal connected to the UP connector (red) of the in-
cluded cable for FOOT SW jack will step upward through
the programs in the order of U00→ ... →U99→P00→......
→P99→U00→... The pedal connected to the DOWN con-
nector (white) will step downward through the programs
in the order of U00→P99→ ... →P00→U99→
...→U00→P99→...
If you’ve assigned the foot switch to “PG” or “Ud,” you
can activate the Bypass function by simultaneously press-
ing both foot switches connected to the two jacks, or acti-
vate the Mute function by holding down both switches
for one second or longer.
SS: The foot switches will start/stop recording and play-
back for Phrase Trainer mode. The foot switch connect-
ed to the UP connector (red) of the included cable for
FOOT SW jack will start/stop recording. The foot switch
connected to the DOWN connector (white) of the cable
will start/stop playback.
With this setting, the foot switches will operate only
when you’re in Phrase Trainer mode.
To Next Page
Loading...
Need help?
General
