37
Effect Parameter List
DYNA: Dynamics & Pickup modeling
TYPE (π/† CURSOR) VALUE (Value encoder)
COMP This compressor produces consistent levels and sustain. Adjusts sensitivity (1.0...10.0).
DYNAEXC
This effect dynamically applies an exciter according to your picking strength.
This is especially effective when you want to give more sparkle to clean sounds.
Adjusts sensitivity (0.0...10.0).
VOX WAH Models a VOX V847 wah pedal.
Adjusts location of the pedal (1.0...10.0).
WAHUP1 Positive-polarity auto-wah that responds sensitively to attacks.
WAHUP2 Positive-polarity auto-wah that responds smoothly to attacks.
WAHDWN1 Negative-polarity auto-wah that responds sensitively to attacks.
WAHDWN2 Negative-polarity auto-wah that responds smoothly to attacks.
Adjusts sensitivity (0.0...10.0).
SLOWATK Smooths the attack to create a violin-like effect. Specify the attack speed (1.0...10.0).
AC SIM An effect that simulates the tonal characters of an acoustic guitar. Adjusts tone (0.0...10.0).
RESO An effect that simulates the metallic body of a resonator guitar.
This is suitable for slide playing.
Specify the body resonance
(0.0...10.0).
OCTAVE* This generates a pitch one octave lower than the original sound, and
mixes it with the original sound to add a sense of depth and low
end. This effect may not operate correctly if two or more strings are
played simultaneously, or when low-pitched strings are played.
Adjusts effect level (0.0...10.0).
RING An effect that produces bell-like sounds. For the cleanest effect, use
the neck pickup, turn down the tone control of your instrument, and
play near the 12th fret.
Specify the frequency (1.0...10.0).
To Next Page
Loading...
Need help?
General
