38
TYPE (π/† CURSOR) VALUE (Value encoder)
RINGUP
RINGDWN
A ring modulator in which the effect changes dynamically
depending on your picking strength.
Adjusts sensitivity (0.0...10.0).
CRUSHER
A new-generation fuzz that produces an extremely destructive distortion.
Specify the degree of destructive-
ness (0.0...10.0).
HUMSGL Pickup modeling that transforms a humbucking pickup into a
single-coil pickup.
SGLHUM Pickup modeling that transforms a single-coil pickup into a
humbucking pickup.
HF TONE
Pickup modeling that simulates the “half-tone” position between two pickups.
PHASOUT Pickup modeling that simulates the “out of phase” sound when two
pickups are connected out of phase.
Adjusts tone (0.0...10.0).
B COMP Compressor for bass with an emphasized attack. Adjusts sensitivity (1.0...10.0).
LIMITER A limiter that makes levels more consistent.
Specify the compression ratio (0.0...10.0).
B OD** Overdrive for bass.
B DIST** Distortion for bass.
B FUZZ** Fuzz for bass.
Amount of distortion (1.0...10.0).
PREAMP1 Preamp set to a clear tone for bass.
PREAMP2 Preamp set to a muted tone for bass.
BALANCE Creates the sound of blending the output of two bass pickups.
Adjusts tone (0.0...10.0).
LOWCUT
Filter that cuts the unwanted low-frequency range. Effective for recording.
Adjusts frequency (0.0...10.0).
FRETLES* Settings that simulate the sound of a fretless bass. Adjusts tone (0.0. ..10.0).
To Next Page
Loading...
Need help?
General
