31
NR: Noise reduction
Increasing this value will produce more noise reduction.
Normally you will adjust this so that you do not hear obtru-
sive noise when the strings are lightly muted.
Adjust the
depth of
noise
reduction
If the NR value is raised excessively, the notes may be cut
off unnaturally. If this occurs, reduce the NR value.
RENAME
Here you can assign a name for each program.
Select the character
▲/▼:
Select the
character location
The following characters can be used:
WRITE
Here you can write (store) a program that you created.
Use the Value encoder to select the writing destination
(User programs only). To cancel writing a program, press
the √ (or ®) CURSOR to select a different screen.
To write the program, press the ENTER/REC button.
When the program has been written, the LCD will indi-
cate “COMPLT” for approximately one second.
Write
Select a user
program
number as the
writing destination
Program number that currently
occupies the writing destination
Before writing an edited program into a different pro-
gram number, be sure that you do not mind overwriting
the data that is currently in that program number. The
program data that is overwritten will be lost.
It is not possible to write to a preset program (P00–P99).
To Next Page
Loading...
Need help?
General
