To Next Page

To Previous Page

6–1: Pattern Edit

117

▼ Page Menu Command

6–1A: Memory Status

This command displays the remaining amount of sequencer memory.

6–1B: Step Recording

Here you can record pattern data using step recording.

Specify the pattern in the tab 1 display, and select this command. The rest of the procedure is the

same as when step recording a track. (However in the case of a pattern, you will return to the

beginning when you reach End of Pattern.) For details refer to “5–1B: Step Recording.”

6–1C: Event Edit

Here you can edit individual data events of a pattern.

Specify the pattern in the tab 1 display, and select this command. The rest of the procedure is the

same as event editing for a track. For details refer to “5–1C: Event Edit.”

6–1D: Pattern Parameter

Here you can make various settings for the pattern speciﬁed in the tab page.

1 Specify a pattern in the tab 1 display.

2 When this command is selected, a dialog box shown at

right will appear.

3 Specify the length of the pattern in Length.

4 Specify the time signature of the pattern in Meter.

This time signature is only temporary; when you Put the

pattern into a song track, the pattern will playback with

the time signature of that measure.

5 To ﬁnalize the pattern settings, press the OK button. To cancel the command, press the Cancel

button.

6–1E: Erase Pattern

This command erases pattern data speciﬁed in the tab page.

1 Specify a pattern in the tab 1 display.

2 When this command is selected, a dialog box shown at

right will appear.

3 If you check All Tracks, all patterns in the song will be

erased.

If it is un-checked, the pattern speciﬁed in the tab 1 display

will be erased.

4 To execute the Erase Pattern command, press the OK button. To cancel the command, press the

Cancel button.

6–1F: Copy Pattern

The musical data of the pattern speciﬁed in the dialog box will be copied to the pattern speciﬁed

in the tab 1 display.

In the built-in sequencer of the TRINITY series, patterns are attached to a speciﬁc song, but this

Copy Pattern command allows a pattern to be used by a different song.

1 In the tab 1 display, select the copy destination pattern.

2 When you select this command, the dialog box at right will

appear.

3 Specify the copy source song and pattern.

4 To execute the Copy Pattern operation press the OK but-

ton. To cancel without executing press the Cancel button.

6–1G: Bounce Pattern

The musical data of the pattern speciﬁed in the dialog box and of the pattern speciﬁed in the tab 1

display will be combined, and placed in the pattern speciﬁed in the tab 1 display.

Be aware that executing the Bounce Pattern operation will affect the musical data as follows:

• The combined musical data will be placed in the pattern speciﬁed in the tab 1 display, but

unlike the Bounce Track operation, the musical data of the pattern speciﬁed in the dialog box

will not be erased.

• The time signature and length after the Bounce operation will follow the settings of the pattern

speciﬁed on the tab 1 display.

Brand	Korg
Model	Trinity plus
Category	Recording Equipment
Language	English

Korg Trinity plus Parameter Guide

Table of Contents

Other manuals for Korg Trinity plus

Questions and Answers:

Korg Trinity plus Specifications

Related product manuals