Korg XE20 - Applying Effects and Equalizer (EQ)

Playing the XE20 (style mode)
17
Turning the reverb on/o
This switches the reverb (an eect that make the sound linger)
on/o.
1.
Press the REVERB buon.
When you press the buon while reverb is being applied,
the reverb will shut o.
When you press the buon while reverb is not being
applied, the reverb will be turned on.
Note:
Some keyboard sets do not use a reverb eect, and
you will not be able to apply reverb for these sets.
This seing will be lost when the power is turned o.
Applying eects
Each keyboard set contains two eects (eects 1 and 2), which
change the nal output depending on the amount of sound that
is sent through the eects (the send level).
Note:
Depending on the type of eect, the change in sound
may not be too noticeable.
1.
Press the SETTING/[MEDIA] buon.
2.
Press the CATEGORY buon t/u to select from the
P14–21 eects (for eect 1 or 2) and the part to which the
eect will be applied (lower, upper 1–3), on the screen.
3.
Use the dial or the +/– buons to set the eect send level.
When the send level is at “0”, the eect will not be heard.
The greater the send level, the more you will hear the eect.
4.
Press the [SHIFT] buon to return to the previous mode.
Tip:
If you want to save your seings, save them as a set list.
Selecting an equalizer (EQ)
You can add an equalizer eect to make the sound outpued
from the built-in speakers easier to listen to, or to adjust the
tonal character of the sound to match the musical genre you are
playing.
1.
Press the SETTING/[MEDIA] buon.
2.
Press the CATEGORY buon t/u to select “P12:Speaker
EQ”.
3.
Select the equalizer using the dial or the +/− buons.
There are eight types of speaker EQ:
Standard
"
Bass Boost
"
Bass Cut
"
Treble Boost
"
Treble
Cut
"
Mid Boost
"
Mid Cut
"
Loudness
"
Standard ...
(The default seing is “Bass Boost.”)
4.
Press the [SHIFT] buon to return to the previous mode.
Tip:
If you want to save your seing, save it as a set list.
1
1
2
3
3