Korg XE20 - SETTING Functions Guide; Basic Usage of SETTING Functions; Changing the Auto Power-Off Function; Pedal Settings (Polarity, Function)

SETTING functions
25
SETTING functions
Basic methods of use
The basic methods of using the SETTING functions are shown
below.
1.
Press the SETTING/[MEDIA] buon.
This will enter the SETTING functions, and
will
blink on the display.
2.
Press the CATEGORY buon t/u and select the
parameter to set.
3.
Turn the dial to select a value.
4.
Aer you are nished, press the [SHIFT] buon to return
to the previous mode.
Main SETTING functions
Changing the auto power-o function
This instrument has an auto power-o function that
automatically turns o the power when the unit has not been
played or operated for a certain length of time. The time interval
is set to 30 minutes at factory default, but this can be changed.
1.
In the SETTING functions, press the CATEGORY buon
t/u several times to select “P23:Auto PowerO”.
2.
Turn the dial to select “Disable” or a specic time aer
which the power will turn o.
3.
Press the [SHIFT] buon to return to the previous mode.
Changing the pedal polarity
If the pedal connected to the FOOT CONTROLLER jack does
not sustain the sound even when pressed, and if the sound
sustains when you take your foot o the pedal, you will need to
change the pedal polarity on this instrument.
1.
In the SETTING functions, press the CATEGORY buon
t/u several times to select “P03:Pedal Polarity”.
2.
Turn the dial to change the polarity.
− (KORG): This is the factory default seing. Use this seing
when using a DS-1H, PS-1 or PS-3 pedal.
+ (Reverse): Use this seing when the eect of the pedal
appears to be reversed.
3.
Press the [SHIFT] buon to return to the previous mode.
Changing the pedal function
Change the pedal function on this instrument to match the type
of pedal connected, whether a pedal switch, expression pedal or
volume pedal.
1.
Connect the pedal to the FOOT CONTROLLER jack.
2.
In the SETTING functions, press the CATEGORY buon
t/u several times to select “P02:Pedal Function”.
3.
Turn the dial to select the pedal function.
No Assign: Use this when you are not using a pedal.
Damper: This is the factory default seing. Select this when
using a damper pedal or a pedal switch like the Korg DS-
1H, PS-1 or PS-3.
Expression: Select this when using a expression pedal like
the Korg EXP-2.
4.
Press the [SHIFT] buon to return to the previous mode.
1
4
3
2