Korg XE20 - Page 33

Appendix
33
I hear unwanted noise.

When the volume for a part is raised, the digital signal
processing may overload the signal, which could cause
distortion or other noises. This is not a malfunction.
Try lowering the volume on each part buon.

You may hear distorted or noisy sounds due to input
overload with certain eects. This is not a malfunction.

In certain electrical environments, you may hear noise due
to a ground loop or other factors.
The pedal switch or expression pedal connected to the
FOOT CONTROLLER jack doesn’t work like it should.

The functions or polarity for the pedal might not be set
correctly.
See “Pedal Function” (page 26) and “Pedal Polarity”
(page 26) for these seings in the SETTING functions.

Is the variable range of the expression pedal set correctly?
Calibrate as shown on “Calibrating an expression pedal”
(page 32).
I cannot record a user song.

The maximum number of user songs is 999.
You may need to delete one (see page 24 “Deleting a user
song”.)
MIDI signals sent to/from this instrument and a
computer are not being correctly received.

Is the USB cable connected correctly to the USB TO HOST
port?
The instrument does not let me access the MEDIA
functions.

Is your USB ash drive correctly plugged in?
If the USB ash drive is correctly plugged in, you should see
in the display.