Kospel KDE2 - Page 11

EN-045BC_f.1179
11
Number
of impulses
(green indicator)
description
1
The unit was switched off because the temperature has exceeded the
maximum value (fault signal will not disappear until the appropriate rate of
water ow is reached).
2 The unit was switched off by a master appliance.
3 The inlet temperature sensor failure.
4
The unit was switched off because the air bubbles in the heating box (the
unit will not heat again until the fault is resolved and the appropriate rate of
water ow is reached).
The heater switches on automatically straight after reaching the ow rate over
2,5l/min. The temperature control system adjusts the power rate according to the water
ow rate, required temperature and the water temperature in the mains.
There are two indicators on the case:
- green - power supply „on”,
- red - heating „on”.
Other modes are shown by ickering green light.
KDE, KDE2 Operation