15
2.2.2 Ignition method (refer to instructions)
1.
Make sure the clutch in stop position
2.
Turn the fuel tap to the ON position
3.
Turn the throttle valve to the OFF position
Suggestions: no need this step when the engine is hot
4.
Turn the accelerating lever to the high position a little
5.
Turn the main switch to the ON position
6.
Pull the cable, start the engine
7.
Turn the accelerating lever to the lower position after running the
engine
8.
Turn the throttle valve to the staring position
9.
1-2 minutes working without any burden to warm up the machine
Suggestions
After you have the machine, the first week(about 40-50H)just for running,
avoid any overloading
The way of starting
1. Please ensure the clutch lever is still in “leave” .
2. Please ensure the emergency switch is “on”.
3. Start the power button in the open position.
CAUTION
At winter or dry and cold environment, please warm up before driving, if not, it
will reduce the service for the machine
WARNING
Start the engine at ventilated area to avoid get poisoned
Start the engine after make sure the surroundings is safe
Make sure the clutch is at the stop position before start the engine and to
avoid the machine from running to cause any accidents
To Next Page