BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b330.fm 3-53
Operation
3.40 Seat belt (lap belt)
Specific instructions regarding the seat belt
In order to avoid injuries, fasten the seat belt (lap belt) when driving the wheel
loader!
☞ Bear in mind the following when fastening the seat belt:
• The seat belt must not be twisted as you fasten it!
• Seat belt must run over the hips – not over the stomach – and must
always be applied tightly!
• Do not place the seat belt over hard, edged or fragile items (tools, meter
rule, glasses, pen) carried inside your clothes!
• Never buckle up several persons!
• Check the condition of the seat belt regularly. Have damaged seat belts
immediately replaced by an authorised workshop!
• Always keep the seat belt clean, as coarse dirt can impair proper func-
tioning!
• After an accident the belt strap is stretched and must be replaced by a
new one by an authorised workshop!
Fastening the seat belt
☞ Fasten the seat belt as follows before moving off:
• Hold the belt at buckle latch A and run it slowly and steadily over the hips to buckle B
• Insert buckle latch A into buckle B until it engages audibly (pull test)
• Tighten the seat belt by pulling at its end
➥ The seat belt must always be tightly in place over the hips!
Fig. 88: Seat belt symbol
Fig. 89: Fastening the seat belt
B
A
To Next Page
Loading...
Need help?
General
