Kramer KIT-400 Quick Start Guide

KIT-400 Quick Start
P/N:
2900- 30138 8 QS
Rev:
3
Scan for full manual
KIT-400 Quick Start Guide
This guide helps you install and use your KIT-400 for the first time.
Go to www.kramerav.com/downloads/KIT-400 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
KIT-400, including:
KIT-400T 4K HDMI/PC Auto Switcher Transmitter
and KIT-400R 4K HDBT/HDMI Receiver/Scaler
2 Bracket sets
8 Rubber feet
1 Power adapter and cord
1 Quick start guide
Step 2: Get to know your KIT-400
KIT-400T
#
Feature
Function
1
IN 1
SELECT Button
Press to select the IN 1 input.
Lights red when the analog audio is selected; lights green when the embedded
audio is selected.
2
HDMI Connector
Connect to an HDMI source.
3
IN 2
SELECT Button
Press to select the IN 2 input.
Lights red when the analog audio is selected; lights green when the embedded
audio is selected.
4
HDMI Connector
Connect to an HDMI source.
5
IN 3
SELECT Button
Press to select the IN 3 input.
Lights red when the analog audio is selected; lights green when embedded audio
from embedded HDMI is selected, see Step 4: Connect inputs and outputs.
6
15-pin HD Connector
Connect to a PC graphics source.
7
AUDIO IN 3.5mm Mini Jack
Connect to an unbalanced, stereo audio source (for example, the audio output of
the laptop).
8
IN 4 (REMOTE) Button
Press to select the inputs on KIT-400R:
• Button lights – HDMI INPUT on KIT-400R is selected as the input.
• Button off – The selected input on KIT-400T is routed via HDBT.
9
ON LED
Lights green when the device is powered by a power adapter; lights red when
power is provided via PoC.
10
AUDIO OUT 3.5mm Mini Jack
Connect to the unbalanced, stereo audio acceptor (for example, active speakers).
11
LAN RJ-45 Connector
Connect to the LAN (Ethernet traffic or PC controller).
12
RS-232
CONTROL 3-pin Terminal
Block Connector
Connect to a serial controller or PC.
13
DATA 3-pin Terminal
Block Connector
Connect to a serial data source or acceptor.
14
Remote Contact-closure 4-pin
Terminal Block Connector
Connect to contact closure switches (by momentary contact between the desired
pin and GND pin) to select an input, the remote IN 4 and audio volume (up or
down), see Step 6: Operate KIT-400.
15
RESET Button
Short press: sends a reset command to KIT-400R and then reboots KIT-400T.
Long press: resets KIT-400R to its factory default parameters and then resets
KIT-400T to its factory default parameters.

Kramer KIT-400 Specifications

General

Category	Receiver
Model	KIT-400
Maximum Resolution	Up to 4K@60Hz (4:4:4)
Max. Data Rate	18 Gbps
Power Supply	5V DC
Video	HDMI 2.0
Range	Up to 100m